|
The first (blue) measurement is the correct diagonal at Gauge. The next is the correct
measurement if you're 10 mm low. The smaller red Error number is the Plumb
Error for this course at this gauge error. If the Error measurement becomes
significant, use the appropriate diagonal measurement for your gauge error.
Pull your tape from the origin point and using a fine tipped white marker, mark the correct measurement for
each course. Lay the blocks to the tape mark.
As any deviation to gauge will cause plumb errors, the sheet lists correct measurements for variance in gauge,
as well as plumb errors for gauge variance.
Check the gauge occasionally and if the plumb error is significant, use the alternate measurement on the sheet.
The calculator sets the circle or arc out to suit blocks, giving the inside
and outside perp measurements and allowing you to open or tighten the perps (bond) in quarter block increments to a suitable size.
It calculates the 'block + perp' outside measurement, so you can check your bond as you go around. Eg: if the outside 'block + perp' is 418 mm, and you've
laid 10 blocks on the way around, 10 X 418 is 4180. Pull a tape around the outside of the arc to see if you're 'back' or 'forward'.
|
Running Bond around outside (from outside start of first (or any) stretcher, to end of each block)
If you've benefited from this free service, please consider a small donation to
Please help promote this free service - Tell a Friend
Wonga Beach Q.L.D. Australia
Questions or Suggestions? ph: +61 7 40987645
ALWAYS CHECK WITH YOUR LOCAL BUILDING AUTHORITY BEFORE LAYING OUT
OR BUILDING ANYTHING
AND FOLLOW ALL LOCAL CODES. VERIFY ALL DIMENSIONS AND
ANGLES BEFORE CONSTRUCTION
Disclaimer |
Privacy
|